Mold Remediation in Gilbert, AZ — Find It, Remove It, Fix the Source

Gilbert is dry most of the year, so people are surprised to find mold. It shows up for a few specific reasons:

• Slab leaks and supply-line failures. Thousands of Gilbert homes built in the late 1990s and early 2000s are hitting the age where copper lines and water heaters fail. A slow slab leak keeps the bottom of a wall damp for months before anyone notices.
• AC condensate leaks. Air handlers in the attic or a closet run for months in the summer. A clogged condensate line drips into drywall and insulation where it is dark, warm and never dries.
• Monsoon moisture. From July to September, humidity spikes and storms push water under doors and through roof flashing. Wet materials in a closed-up house grow mold within 24 to 48 hours.
• Flood irrigation and low lots. In parts of Gilbert, especially older neighborhoods around the Heritage District and along Guadalupe Road, water pooling against slab foundations wicks up into baseboards and drywall.
• Bathrooms without enough ventilation. The most common small mold job we see — behind tile, under vanities and around tub surrounds.

1. Inspection and moisture mapping. We use moisture meters and infrared imaging to find every wet area — not just the spot you can see — and identify the moisture source.
2. Testing. Where needed, air and surface sampling through an independent lab so you have documented results before and after.
3. Containment. Plastic barriers and negative air pressure so spores do not spread into the rest of your home during removal.
4. Removal. Following IICRC S520, we remove materials that cannot be saved (wet drywall, insulation, damaged cabinets) and HEPA-vacuum and treat what can.
5. Drying and source repair. Because we are an Arizona ROC-licensed contractor (#364257), we fix the leak, dry the structure and put the wall back — you do not need a second contractor.
6. Clearance. The job is not done until post-remediation testing confirms the area is clean.

Mold caused by a sudden, covered water loss (a burst pipe, an appliance failure) is often covered, sometimes with a cap. Mold from long-term neglect usually is not. We document the cause and the moisture readings so the claim has the best chance, and we write estimates in Xactimate, the same software your adjuster uses. If a claim is not the right path, we will tell you and give you a straightforward price.

We serve every Gilbert neighborhood, including Power Ranch, Agritopia, Morrison Ranch, Val Vista Lakes, Seville, Spectrum, Higley Groves, The Islands, Lyons Gate and the Heritage District — ZIP codes 85233, 85234, 85295, 85296, 85297 and 85298. Our office is at 557 E Juanita Ave in Mesa, minutes from the Gilbert line.